TROUBLESHOOTING > 75
INPUT JAM
1. Remove the paper tray from the printer.
2. Remove any crumpled or folded paper.
3. Remove any paper from the underside of the printer.
4. Replace the paper tray.
After successful removal of any damaged or misfed paper, the printer
should continue printing.
FEED JAM OR EXIT JAM
1. Remove the tray and clear any misfed sheets as given above.
2. Open the top cover.
3. Carefully lift out the image drum, complete with the toner
cartridge. Be careful not to touch or scratch the green drum
surface.
4. Remove any jammed sheets from the paper path.
5. Re-install the image drum complete with toner cartridge, ensuring
that it correctly locates into the slots on each side of the printer.
6. Close the top cover and press down to latch it closed.
WARNING!
The fuser area will be hot. This area is clearly marked. Do not touch it.
CAUTION!
Never expose the image drum unit to light for more than 5 minutes. Never
expose the image drum unit to direct sunlight. Always hold the image drum
unit by the ends or from the top. Never touch the surface of the green drum
inside the image drum unit.
To Next Page
Loading...
