Consumables and maintenance > 62
If you do spill any toner powder, lightly brush it off. If this is not enough, use a cool, damp
cloth to remove any residue. Do not use hot water, and never use solvents of any kind.
They will make stains permanent.
1. Switch off the printer and allow the fuser to cool for about 10 minutes before
opening the top cover.
2. Press the top cover release button and open the printer’s top cover fully.
3. Pull the colored lever (1) on the right side of the toner cartridge towards the front of
the printer to close the cartridge then remove the used toner cartridge (2).
4. Clean the top of the ID unit with a clean, lint free cloth.
5. Put the cartridge down gently onto a piece of paper to prevent toner from marking
your furniture.
6. Remove the new cartridge from its box but leave its wrapping material in place for
the moment.
WARNING!
If you inhale any toner or get it in your eyes, drink a little water or
bathe your eyes liberally in cold water. Seek medical attention
immediately.
WARNING!
If the printer has been powered on, the fuser may be hot. This area
is clearly labelled. Do not touch.
NOTE
The B430dn model has been illustrated below. The principles are the same for
all models of this printer.
1
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
