B6250/B6500 User’s Guide> 21
S
ETTING
C
USTOM
P
APER
S
IZES
Before printing, set the custom size on the printer driver.
You have to configure the settings on the control panel too when
loading custom size paper in trays 1 to 4 for printing. For details on
setting the control panel, refer to “Setting Custom Paper Sizes” in
the Reference Guide.
On the printer driver, set the custom size in the [Paper Size] dialog
box. This section explains the procedure using Windows XP as an
example.
NOTE
For Windows NT 4.0/Windows 2000/Windows XP, only users with
administrator’s rights can change the settings. Users without the
rights can only check the contents.
1. From the [File] menu, click [Print].
2. Select [Properties] then select the [Setup] tab.
3. Select Option as needed: Source, Media Type, etc.
4. You may select a previously stored custom size from the list
or you may add an additional custom size.
5. To add a new custom size:
A. Select paper feed options.
B. Select Custom Size.
C. In the Name Field, Type a name for your custom size.
D. Click on the Unit of measure radio button for the units
you would like to use (mm for millimetres or inch for
inches.)
E. In the Width field, enter the width of the custom size
paper.
CAUTION!
When setting the paper size on the printer driver and
the control panel, specify the size of the actual paper
used. Setting the wrong size for printing will cause jam
detection. This is especially true if you configure a
bigger size when using a narrow width paper.
To Next Page
Loading...
Need help?
General
