44015503TH Rev. 1
217 /
Oki Data CONFIDENTIAL
7. TROUBLESHOOTING PROCEDURE
Ground
Charge roller
Developer roller
Toner feed roller
Figure 7-3
7.5.3.(8) For the entire monochrome print, it does not being printed.
(8-1) Setting by mistake of the specific color print menu
Check item Check work
Action to be taken
at NG
(8-1-1) Status of specific color print menu
Boot Menu item Check if the set value item of “Process Setup” of
Boot Menu is the setting of “Full Color”. (About
Boot Menu, refer to Section 5.6)
Setting
alteration for
“Full Color”
To Next Page
Loading...
Need help?
General
