OkiLAN 8200e Network User’s Guide
60
Configuration:
Using TELNET
Example TELNET Configuration, Sun Solaris 2.4
TELNET requires the print server to have a valid IP address configured. If
the NIC already has an IP address configured, skip steps 1 to 3 below.
1. Login as [root].
If you do not have Superuser rights, the network manager should run
the configuration.
2. Set a temporary IP Address on the NIC using the ARP command.
Example
For IP address 172.168.20.127 and network card address
00:80:92:01:00:D2:
# arp –s 172.168.20.127 00:80:92:01:00:D2 temp
Important!
Please ensure that a valid IP address for you network environment
is used. Use of an incorrect IP address can cause serious problems
on your network.
NOTE
The method of configuring commands may differ
between workstations. Refer to the workstation’s
manual.
NOTE
The Ethernet address (MAC address) is displayed
during the self-diagnostic test (see page 9). A
temporary address does not need to be set if an IP
address has already been set.
To Next Page
Loading...
Need help?
General
