Oki C9600n

Printing from Windows: Using TCP/IP Protocol • 162
7. Click [Next].
"Welcome to the Add Standard TCP/IP Printer Port Wizard"
appears.
8. Click [Next] and enter [Printer name or IP address], for
example: 172.168.1.31. If the example IP address is entered,
the Port Name will default to IP_172.168.1.31.
9. Click [Next].
The “Additional Port Information Required” windows appears.
10. Under [Device Type], click [Custom] → [Settings].
11. Ensure [Protocol] is set to [LPR].
12. Ensure [Queue Name] is lp and [SNMP Status Enabled] is
deselected.
13. Click [OK].
14. Follow the on-screen instructions to finish the installation.
Port 9100
1. Click [Start] → [Settings] → [Control Panel] → [Printers and
Other Hardware].
2. Click [Printers and Faxes].
3. Click [Add Printer] → [Next].
4. Click [Local printer attached to this computer], clear the
[Automatically detect and install my Plug and Play printer]
check box.
5. Click [Next].
6. Click [Create a New Port] and click [Type Standard TCP/IP
Port].
7. Click [Next].
The "Welcome to the Add Standard TCP/IP Printer Port
Wizard" appears.
8. Click [Next] and enter [Printer name or IP address], for
example: 172.168.1.31. If the example IP address is entered,
the Port Name will default to IP_172.168.1.31.