- 30 -
2. Copy
This function is useful when you want to copy multiple books.
To scan multiple sets of documents and make copies as a single job, enable the Continuous
Scan mode. This mode is useful when using the [Sort], [N-in-1], or [Duplex Copy] function.
In Continuous Scan mode, you can copy your documents from the ADF, document glass, or
both of them.
Sorting Each Set in Page Order (Sort)
Combining Multiple Pages on One Sheet of Paper (N-in-1)
Copying on Both Sides of Paper (Duplex Copy)
Cancelling Copying (User's Manual)
1
Press the (COPY) button on the operator panel.
2
Set the first sheet of a document in the ADF or on the document glass.
When making N-in-1 and/or duplex copies by using the document glass, the [Please set next document] screen
is displayed after scanning the documents even if [Continuous Scan] is set to [OFF].
3
Press the button.
4
Press the or button to select [Continuous Scan] and press the
button.
5
Press the or button to select [ON] and press the (OK) button.
6
Press the button to go back to the standby screen.
7
Enter the number of copies by using the numeric keypad.
8
Press the (MONO) or (COLOR) button.
9
When the [Please set next document.] screen is displayed, set the next
document in the ADF or on the document glass.
When changing the place to set the next document, be sure to remove the document from the place you used first.
10
Check that [Start Scan] is selected, and then press the (OK) button.
11
When scanning all sets of the documents is complete, press the button to
select [Scan Complete] and press the (OK) button.
If you select [Scan Complete] after scanning all the documents with multiple copies (2 or more) being set for
[Copies] and press the (OK) button, the remaining number of copies are copied.
Enabling Continuous Scan Mode (Continuous Scan)
To Next Page
Loading...
Need help?
General
