- 431 -
11. Utility Software
This section describes how to forward selected print jobs to a registered device using the OKI
LPR Utility. This section also describes how to automatically forward a print job to a different
registered device when a problem occurs on the forward destination device.
• Print jobs can only be forwarded to a device of the same model as your device.
• Before forwarding a job, you must add a device.
• Forwarding the Selected Print Jobs
1
Start OKI LPR Utility.
2
Select [Job Status] from the [Remote Print] menu.
3
To forward a print job, select a job, select [Redirect] from the [Job] menu, and
then select the destination device.
• Forwarding Print Jobs Automatically
If you are unable to print because the selected device is busy, offline, out of paper,
or due to other reasons, you can set so that a print job can be automatically
forwarded to another OKI model device.
You must log in as the administrator.
1
Start OKI LPR Utility.
2
Select the device to set.
3
Select [Confirm Connections] from the [Remote Print] menu.
4
Click [Details].
5
Select the [Automatic Job Redirect Used] check box.
6
To forward jobs only if an error occurs, select the [Redirect only at the time of
an error] check box.
7
Click [Add].
8
Enter the forwarding destination IP address, and then click [OK].
9
Click [OK].
Forwarding Print Jobs to a Registered Device
To Next Page
Loading...
Need help?
General
