Oki MC363dnw Advanced Manual

- 67 -
3. Scan
• If a computer for WSD Scan recognizes this machine and the IP address of this machine is changed, you must
register from the beginning. Uninstall this machine, and then install it again.
• Before starting this installation, check that Network Search is enabled.
From [Control Panel], click [Network and Internet] > [Network and Sharing Center] > [Change advanced sharing
settings], select [Turn on network discovery] for [Network discovery], and then click [Save Changes].
You can register up to 50 computers in this machine.
1
Select [Computer] from the [Start] menu and select [Network].
2
Right-click the [OKI MC563] icon under [Multifunction Devices], and then
select [Install].
If the [User Account Control] dialog box is displayed, click [Yes].
3
When a balloon message is displayed to inform you that the installation is
complete on the task bar, click the balloon to check the details, and then click
[x (Close)].
4
Press the (SCAN) button on the machine.
5
Press the button to select [Computer] and press the button.
6
Press the button when [Select A Connecting PC] is displayed.
7
Press the or button to select [From WSD Scan] and press the (OK)
button.
8
Check that a computer is displayed on this machine as a connection
destination of WSD Scan.
Setting a Binding Position for Duplex Scanning (WSD)
To set a binding position for duplex scanning with Scan To Computer and Remote Scan via
WSD Scan, follow the procedure below.
1
Press the (SETTING) button on the operator panel.
2
Press the button to select [Admin Setup] and press the button.
3
Enter the administrator password, and then press the (OK) button.
The factory default administrator password is "999999". If the administrator password is changed, enter the
updated password.
4
Press the or button to select [Scanner Setup] and press the button.
5
Press the or button to select [WSD Scan Setup] and press the
button.
6
Press the or button to select [Binding] and press the button.
7
Press the or button to select biding position, and then press the
(OK) button.
8
Press the button until the home screen is displayed.
Starting Scanning from a Device (WSD)
1
Press the (SCAN) button on the operator panel.
2
Set a document in the ADF or on the document glass.
3
Press the button to select [Computer] and press the button.
4
Check that [Select A Connecting PC] is displayed, and then press the
button.
5
Press the or button to select [From WSD Scan] and press the (OK)
button.
6
Select a destination computer to which the data is sent.
7
Press the (MONO) or (COLOR) button.
Operating Scan Function from a Computer (Remote Scan) (WSD)
Select a WSD scanner driver from a scanner supported application and scan.
Using a Scanner Supported Application

Oki MC363dnw Specifications

General

Brand	Oki
Model	MC363dnw
Category	All in One Printer
Language	English