Microline 8480FB User’s Guide
Function Setting Menu • 38
Front Feed TOF 2.12 mm (1/12”), 3.18 mm
(1/8”),
6.35 mm (1/4”)
, 8.47
mm (1/3”), 10.58 mm (5/12”),
19.05 mm (9/12”), 23.28 mm
(11/12”), 25.4 mm (1”), 27.52
mm (13/12”), 1Chr. Set Pos.
Note:
1Chr. Set Pos. automatically
appears as the setting when the
front panel has been used to set a
1Chr. Set Pos value for the Front
Feed path (see page 58).
Form Tear-Off
Off
, On
Initial Pos.
Print
, Tear Off
PE Pos. 3.18 mm (1/8”),
6.35 mm
(1/4”)
Gap Control
Auto
, Manual Gap x
x = 1 to 8, A to E (see page 67)
Gap Pos.
50.8 mm (2”)
, 101.6 mm (4”)
Rear Feed Not Used.
Adjustment TOF Adj. (Cut) -40 to
0
to +40
in increments of 1/120 inch
TOF Adj.(CSFF) Not Used.
TOF Adj.(CSFR) Not Used.
Front Load Adj. -40 to
0
to +40
in increments of 1/120 inch
PE Adj. (Cut) -15 to
0
to +15
in increments of 1/120 inch
PE Adj. (CSFF) Not Used.
PE Adj. (CSFR) Not Used.
PE Adj. (Front) -15 to
0
to +15
in increments of 1/120 inch
PE Adj. (Rear) Not Used.
Group Item Settings
To Next Page
Loading...
