ML1120 Plus/ML1190 Plus User’s Guide - Paper handling > 25
loading continuous forms
setting uP continuous forms
To avoid paper feeding problems, carry out the following:
1. Check your printer is on a surface approximately 75 cm above
the floor.
2. Position the continuous forms supply directly below the printer,
no more than 3 cm left or right of the printer paper path.
3. Ensure the rear of the printer is close to and parallel with the
edge of the surface and at least 60 cm from any wall.
feeding continuous forms
1. Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in "Ejecting
cut sheet paper" on page 24.
2. Set the Paper Type Lever to Continuous Forms .
To Next Page
Loading...
