ML1120 Plus/ML1190 Plus User’s Guide - Operating instructions > 63
MENU ITEM FUNCTION SETTING
Set-up menu Print Style Set quiet printing. Normal
Quiet
Centering
position
(continuous)
Set the centering position
for the print head by the
number of characters of
10CPI ANK.
Default
Mode1
Mode2
Centering
position (cut
sheet)
Set the centering position
for the print head by the
number of characters of
10CPI ANK.
Default
Mode1
Mode2
Power Save Time Select the time to enter
the Power Save mode.
5 min
10 min
15 min
30 min
60 min
Paper End Select whether a printer
status where no paper is
loaded is set to SEL or
DESEL.
On-line
Off-line
Parallel I/F I-Prime Set I-Prime signal
control of the Centronics
interface.
Invalid
Buffer Print
Buffer Clear
Auto Feed XT Set whether to enable
or disable Auto Feed XT
signal of the Centronics
interface.
(EPSON emulation only)
Valid
Invalid
Bi-Direction Set whether to enable
or disable Two-way
communication of the
Centronics interface.
Enable
Disable
Serial I/F Parity Set parity. None
Odd
Even
Ignore
Serial Data 7/8
Bits
Set serial data length. 8 bit
7 bit
Protocol Set protocols. DTR
X-ON/X-OFF
DTR & X-ON/X-OFF
Diagnostic Test Set/Cancel loop testing of
the serial interface.
No
Yes
To Next Page
Loading...
