Oki ML186 - For Example

48 • Operating Your Printer
For Example
The default setting for the zero character is slashed. To change the
setting to unslashed:
1.Press and hold SELECT while turning the printer on.
The following line prints:
Printer Control Emulation Mode IBM
2.Press LINE FEED several times until the Symbol Sets group line
appears:
Symbol Sets Character Set SetI
3.Press FORM FEED repetitively until the Zero Character item line
appears:
Symbol Sets Zero Character Slashed
4.Press TOF SET once.
The following line prints:
Symbol Sets Zero Character Unslashed
5.Press PITCH and MODE together to save the setting and exit the
Menu Mode.