40496501TH Rev.1 136
E Alarm lamp flashes. Message on the LCD “ERROR, FLASH UNLOAD”
Is a flash memory used?
Yes No
• Confirm the settings of the short plug T3 on the PMA board.
1-2 setting: FLASH ROM selected
2-3 setting: EP ROM selected
• Has the EPROM been selected?
Yes No
• Make a proper selection for the short plug.
▼
• Replace the PMA.
▼
• Can the printer recover after the program to the FLASH ROM is replaced?
No Yes
• End
▼
• Replace the PMA board.
To Next Page
Loading...
