40496501TH Rev.1 67
3.3.13 Head Cooling Fan 1
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear / Plate Front (stuck). (See 3.3.1)
(2) Unplug the connector 1 from Junction Board (PRA Printed Board)(CN6) 6.
(3) Release the cords from the cord clamps on the cord route.
(4) Unscrew 2 screws 2 and remove SP Motor Fan Assy 3.
(5) Unscrew 2 screws 5 and remove Head Cooling Fan 1 5.
(6) For installation, reverse the removal procedure.
(Note on Installation)
1. The fan should be installed, matching the direction of air flow to the direction of arrow shown
in the figure.
1
6
2
3
4
5
CN6
Air Flow
To Next Page
Loading...
