40496501TH Rev.1 73
3.3.19 Head Cable
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear / Plate Front (stuck). (See 3.3.1)
(2) Remove Printing Head. (See 3.3.18)
(3) Remove Printer Unit. (See 3.3.2)
(4) Remove Cable Holder Cover. (See 3.3.6)
(5) Unscrew the screw 1 and remove Carriage Cable Holder 2.
(6) Unplug Head Connector 3 and then the connector (green) 4.
(7) Unscrew 2 screws 5 and remove Head Cable Cover 6.
(8) Unplug Head Cable 7, pulling it to the left.
(9) For installation, reverse the removal procedure.
(Note on Installation)
1. When the head cable is assembled, make sure that 0.5 - 1.5mm clearance between cables
should be secured and the amount of protrusion from the side frame (R) should be approx.
10mm on condition that the carriage is dhifted to the left end.
1
2
3
5
6
4
7
0.5 – 1.5
0.5 – 1.5
0.5 – 1.5
0.5 – 1.5
10
Side frame (R)
Head cable
Head cable guide
The condition of cables when the carriage is shifted to the left end
To Next Page
Loading...
