40496501TH Rev.1 212
2. Maintenance mode 1
(1) DIP Switch Settings
(2) Power ON Switch Function
DIP Switch
(O: ON, X: OFF, –: ignored)
Function
3412
Maintence function enabled mode
–––
Switch
Function
(Valid when DIP switch-1 is ON)
SHIFTON-
LINE
PATH/
TOF
CON-
FIG
LFFF/
LOAD
PARKTEAR
Starts learning function for slice level of
paper width sensor.
Starts auto-gap test.
Gap open/close test.
Starts gap close.
Starts ON/OFF test for all sensors.
Starts the alignment of print start position
sensor.
Resets the counter of print character
number
Starts AG correction mode.
Starts AG adjustment aid mode.
Flash Loading Mode
Starts aging mode (10 min.)
Starts aging mode (5 min.)
The above switches are also valid during Limited Operation.
The empty boxes indicate not-pressed switches.
: indicates that the switch is pressed.
To Next Page
Loading...
