40496501TH Rev.1 87
C
E
A
A
2
3
8
4
7
0
9
6
5
4
B
1
6
9
D
E
D
Gear
Wave washer Wave washer
Bush
Washer
Bush
Left Side Flame
Bush
Washer
Bail Lift Lever(L)
3.3.31 Bail Assy
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear / Plate Front (stuck). (See 3.3.1)
(2) Remove Mini Pitch Belt. (See 3.3.9)
(3) Remove Bail Motor Assy (See 3.3.11)
(4) Remove 2 Drive Pulleys 1.
(5) Unscrew 2 screws 2 and remove Bail Gear Assy 3.
(6) Release the claws at right/left Drive Gears B 4 then remove Drive Gears B 4, Wave Washers
5 and Flat Washers 6.
(7) Slide Bail Lift Lever (R) 9, Drive Gear B 7 and Drive Gear C 8 to the oblique upper direction
and remove Bearing (Bail) 0.
(8) Remove 2 Bail Springs A.
(9) Remove Screw Stud B.
(10) Slide Bail Support Shaft C to the right then remove it from left Bearing (Bail) D.
(11) Lift Bail Assy E to the oblique upper direction and pull it out to the left.
(12) For installation, reverse the removal procedure.
(Note on Installation)
1. The wave washers should be attached, paying attention to the direction of them.
2. The phase of bail lift lever (L), (R) should be matched in assembling them.
To Next Page
Loading...
