40496501TH Rev.1 86
Wheel
Wheel
Pin wheel
Match the position of marks
Rear tracor Assy Gears phase drawing
4
Match the direction of projections
8 Assembling friction piece
Open up the notch to 1mm and assemble it,
positioning the notch as shown in figure.
Notch is rotated by 45°
Rotated notch
45°
1. Matching the phase of pin tractors
a. Match the direction of pin wheel projections on right/left pin tractor to that of mark on the 2
(rear tractor drive gear).
b. Match the direction of wheel projections on right/left pin tractor to that of mark on 4 (drive gear
B), and install 2 (drive gear B) to 53 (rear drive shaft of the rear tractor Assy) at a position
where the directions of marks on 4 (drive gear B) and 2 (rear tractor drive gear) match.
To Next Page
Loading...
