40496501TH Rev.1 88
4. ADJUSTMENTS
(1) Be sure to carry out this adjustment with the printer mechanism mounted on the lower cover.
(2) Be sure to carry out this adjustment operation on a level and highly rigid work table (flatness:
less than 0.039 inch or 1 mm) so as to minimize adjustment error.
[Service Tool]
• No. 2-200 Philips screwdriver
• No. 2-200 screwdriver
• Feeler gauge
• 500 g rod tension gauge
• Calipers
Adjustment should be conducted after removing the Rear Cover (B) and setting the Dip Switch 1
on the board to “ON”(maintenance mode). (See Note 1 and 2)
Note 1: After the adjustment and lubrication have completed, set the all the dip switches to
“OFF”(normal operation mode), and fix the Rear Cover (B) with the mounting screws.
Note 2: The local test printing except for the menu printing should be implemented with all the dip
switches set to “OFF”(normal operation mode).
To Next Page
Loading...
