40496501TH Rev.1 148
5 Alarm lamp flashes, LCD reads “ERROR, RIBON JAM”
Is the ribbon feed during initialization?
Yes No
• Is the connection of cable properly made to the CN1 and the CN9 on the PRA board?
Yes No
• Properly reconnect it.
▼
• Is the connection of cable properly made to the CN2 on the PMA board?
Yes No
• Properly reconnect it.
▼
• Can the printer recover after the ribbon motor is replaced?
No Yes
• End
▼
• Can the printer recover after the ribbon gear Assy is replaced?
No Yes
• End
▼
• Can the printer recover after the PMA board is replaced?
No Yes
• End
▼
• Can the printer recover after the connection cable between the CN1 on the PRA board
and the CN2 on the PMA board is replaced?
No Yes
• End
▼
• Replace the PRA board.
▼
• Has the ink ribbon rotation sensor been properly installed?
Yes No
• Properly reinstall it.
▼
• Is the connection of cable properly made to the CN4 and the CN1 on the PRA board?
Yes No
• Properly reconnect it.
▼
• Is the connection of cable properly made to the CN2 on the PMA board?
Yes No
• Properly reconnect it.
▼
• Can the printer recover after the cover open switch and/or ribbon rotation sensor cable is replaced?
Yes No
• End
▼
• Can the printer recover after the PMA board is replaced?
No Yes
• End
▼
5-1
To Next Page
Loading...
