40496501TH Rev.1 158
9 The printer can normally operate, but not start printing.
• In the event of the use of optional serial board, go to 9-1 .
• In the event of the use of MUPIS card, go to 9-2 .
• Can the printer perform the self-test.
Yes No
• Replace the PMA board.
▼
• Is the interface cable properly connected?
Yes No
• Properly reconnect it.
▼
• Can the printer recover after the interface cable is replaced?
No Yes
• End
▼
• Which of parallel or serial is used for the interface?
Parallel Serial
• Is the settings of serial interface correct?
Yes No
• Accurately reset it.
▼
• Is the connection of cable properly made to the CN6 on the PMA board and the CN1 on the PHA
board?
Yes No
• Properly reconnect it.
▼
• Can the printer recover after the connection cable between the CN6 on the PMA board and the
CN1 on the board is replaced?
No Yes
• End
▼
• Can the printer recover after the PHA board is replaced?
No Yes
• End
▼
• Replace the PMA board.
To Next Page
Loading...
