40496501TH Rev.1 160
9-2
Can the printer perform the self-test printing.
Yes No
• Replace the PMA board.
▼
• Is the network cable (LAN cable) properly connected to the MUPIS card?
Yes No
• Properly reconnect it.
▼
• Can the printer recover after the network cable (LAN cable) to the MUPIS card is replaced?
No Yes
• End
▼
• Confirm if the printer recognizes the MUPIS card using the menu. Check If “OKI HSP” appears
in Set when “Set-up” is selected for Group and “Host Interface” for Item in menu setting. If it can
be found, the printer can be considered to recognize this card.
• Can the printer recognize the card?
Yes No
• Is the MUPIS card properly connected to the PMA board?
Yes No
• Properly reconnect it.
▼
• Replace the MUPIS board.
▼
• Replace the PMA card.
To Next Page
Loading...
