40496501TH Rev.1 92
Item No.
7
8
Items
Auto Gap Motor Assy
Backlash
Bail Gear Assy Backlash
Standard Value
J=0.1mm
K=0.2mm
Illustration Adjustment Method
1
Verify the backlash is 0.1 mm bet-
ween the idle gear and the adjusting
cam.
2
If adjustment is required, screw down
the 2 screws fixing the auto gap assy,
and ensure the backlash between the
idle gear and the adjusting cam.
1
Verify the backlash is 0.2 mm bet-
ween the idle gear A and the drive gear
B, and between the idle gear B and the
idle gear C.
2
If adjustment is required, screw down
the 2 screws fixing the bail gear assy,
and ensure the back lash between the
idle gear A and the drive gear B, and
between the idle gear B and the idle
gear C.
Mounting Screws
Mounting Screws
Mounting Screws
Mounting Screws
Bail Gear Assy
Idle Gear B
Idle Gear C
Idle Gear A
Drive Gear B
Adjusting Cam
Change Motor
Idle Gear
J
K
K
To Next Page
Loading...
