Oki Teriostar LP-1040-MF - Printer Settings

107
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
System Menu

Printer Settings
Congures the settings regarding general operation of the Printer.
n
Common Setting
z
Mode Transition Time
Sets the time until standby mode is entered if no buttons are operated.
<Parameter by selecting options>
n
: Default value
30 seconds Sets to 30 seconds.
n
1 minute Sets to 1 minute.
2 minutes Sets to 2 minutes.
3 minutes Sets to 3 minutes.
5 minutes Sets to 5 minutes.
10 minutes Sets to 10 minutes.
15 minutes Sets to 15 minutes.
Note

The time required to enter the standby mode from the menu mode screen
does not depend on this parameter but is always set to 15 minutes.
z
Language
Changes the message display on the screen.
<Parameter by selecting options>
n
: Default value
n
English Italiano Русский
日本語
Français Dutch (NL)
简体中文
Español
繁體中文
Deutsch Português
z
Unit of Length
Changes the unit of length between mm and inches.
<Parameter by selecting options>
n
: Default value
n
mm
Inch
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6