Oki Teriostar LP-1040-MF - Using Paper from a User Defined Series

7979
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
Using Paper from a User Dened Series
The Printer supports the following user dened series rolls.
Standard-size printing cannot be performed with user dened series. All printing is
actual length printing.
279.4 mm (11 inches)to
914.4 mm (36 inches)
Default values:
User Dened 0 = 914 mm (35.98 inches)
User Dened 1 = 620 mm (24.41 inches)
User Dened 2 = 450 mm (17.72 inches)
User Dened 3 = 310 mm (12.20 inches)
This section describes the procedure for operating with a user dened series.
(1) Set the available size standards
In Available Size Standards (
&
page 104), set User Dened to On.
Note

When this setting is changed, the Printer restarts.
(2) Set the user dened size
In the user dened series, four paper widths from user dened 1 to 4 are available.
In User Dened Size, set the width for each (
&
page 106).
Note

When this setting is changed, the Printer restarts.
(3) Set the paper size standards
Set the roll you intend to use to On in Paper Size Standards (
&
page 105). You
are recommended to set all unrequired rolls to O.
Note

It is not possible to set all the user dened series rolls to O.

When this setting is changed, the Printer restarts.
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6