Oki Teriostar LP-1040-MF - Page 123

123
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu
Centering O
Paper feed direction
Cut position Paper feed direction Cut position
X
Y
printed image
Centering On
X
Y
a
b
a
printed image
b
a: Varies depending on the printed image size.
b: Varies depending on the printed image size.
Regardless of the printed image size, the
image is positioned in the center of the paper.
n
Paper Type
The paper type is specied, which is valid at the automatic paper supply with Paper
Supply Mode set to Continuous or Optimal.
<Parameter by selecting options>
n
: Default value
n
Not Specied Does not specify the paper type.
Plain Supplies plain paper.
Tracing Supplies tracing paper.
Film Supplies lm.
n
Excess Size Tolerance (mm)
When an image size exceeds a standard size or a roll paper size, the Printer
identies the image size as the standard size or the roll paper size on the condition
that the excess is within the dened excess size tolerance.
However, note that the part of the image exceeding the used paper size is not
printed, as the actual print area is not aected by the excess size tolerance.
<Parameter by entering numbers>
0 to 30 Default value = 2, Unit in mm
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6