Oki Teriostar LP-1040-MF - Page 279

279
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
Command Lists
(2/2)
Command
Function Supported
Name Code
Simple Color ESC * r # u|U Sets the color mode. Yes
Current Pattern ESC * v # t|T Sets the pattern type for the raster. No
Download Pattern ESC * c # W [pattern data] Loads a user dened pattern. No
Pattern Control ESC * c # q|Q
Species the deletion of a user dened
pattern.
No
Pattern ID ESC * c # g|G Sets the ID of a user dened pattern. No
Pattern Reference ESC * p # r|R Denes the paste position for the pattern. No
Logical Operation ESC * l # o|O
Species the logical calculation mode for the
raster data.
Partially (
8
)
Pattern Transparency Mode ESC * v # o|O
Species transparency mode on/o for the
pattern.
No
Source Transparency Mode ESC * v # n|N
Species transparency mode on/o for the
source raster.
No
(
1
) Parameter value -1 is handled as 0.
Parameter values -1 to 3 have no eect on palette information.
(
2
) Parameter values 0 to 3 have no eect on palette information.
(
3
) Partial pages in the received data are not printed.
(
4
) Parameter 4 in Set Pixel Encoding Mode is not supported.
The speciable range in Set Number of Bit per Index is 1 to 8.
The speciable range in Set Number of Bit per Primary is 0 to 8.
(
5
) The speciable parameter range is 0 to 31 (2**5-1).
(
6
) Pushing and popping are not performed for the pen width.
(
7
) The only parameter value enabled for ESC*t#J is 0.
(
8
) ESC*l#O is enabled only in some logical calculations for monochrome binary raster.
Commands not included in the table result in command errors or are disregarded.
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6