Oki Teriostar LP-1040-MF - Page 98

98
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
System Menu
y
Subnet Mask 01 to 10
Sets the subnet mask of the routing destination network.
<Parameter by entering numbers>
0.0.0.0 to 255.255.255.255 Default value:
0.0.0.0 (not set)
z
This parameter is not applicable when default routing is set.
z
This parameter is applicable when the destination network is set in the network
addresses of the routing table.
y
IPv6 Network Address 01 to 02
Sets the IPv6 network address.
<Parameter by entering characters in IPv4/IPv6 format>
0 to 63 characters
y
Prex Length 01 to 02
Sets the prex length of the routing destination IPv6 network.
<Parameter by entering numbers>
0 to 128 Default value: 64
y
IPv6 Gateway Address 01 to 02
Sets the IP address of the IPv6 router.
<Parameter by entering characters in IPv4/IPv6 format>
0 to 63 characters
z
SNMP TRAP
Settings regarding SNMP TRAP are performed with this parameter.
The TRAP function is enabled when using the print function.
y
TRAP 1 to 5
y
Agent Computer
Sets the IP address of the agent computer to return a trap.
This setting is not required when, at the submission function, the destination is
specied with an IP address.
Before Use Basic Operations Menu Functions
Authentication
Function
Print Job Box
Function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
5
4
6