How
To
Check Power Steering
Fluid
When the engine compartment is cool, unscrew the cap
and wipe the dipstick with a clean rag. Replace the cap
and completely tighten it. Then remove the cap again
and look at the fluid level on the dipstick.
The
level should be at the
FULL
COLD
mark. Add
enough fluid to bring the level up to the mark.
A
fluid
loss
in this system could indicate a problem.
Have the system inspected and repaired.
What
to
Add
Refer to the Maintenance Schedule to determine what
kind of fluid to use. See “Recommended Fluids and
Lubricants” in the Index.
NOTICE:
When adding power steering fluid or making
a
complete fluid change, always use the proper
fluid. Failure to use the proper fluid can cause
leaks and damage hoses and seals.
Windshield Washer Fluid
What
to
Use
When you need windshield washer fluid, be sure to read
the manufacturer’s instructions before use.
If
you will be
operating your vehicle in an area where the temperature
may fall below freezing, use a fluid that has sufficient
protection against freezing.
To
Add
Open the cap labeled WASHER FLUID ONLY. Add
washer fluid until the tank is full.
6-27
To Next Page
Loading...
