The Torx@ screws
(C)
are headlamp aiming screws.
Do
not
turn
these screws. Only a qualified service
technician using proper equipment should adjust these
screws.
Taillamp Bulb Replacement
For the type of bulb, see the Index under “Replacement
Bulbs.”
1.
In the trunk, remove the plastic screw holding the
carpeting in place and pull back the carpeting.
If
you
have the optional convenience net, you must first
remove it from the hooks.
2.
Pull the carpet away from the rear corner
of
the
trunk.
3.
Rotate the bulb housing
1/8
turn and remove it.
4.
To
remove the bulb, push in and rotate
it
counterclockwise.
5.
Replace the bulb.
6.
Reverse the steps to reassemble the taillamp.
6-34
To Next Page
Loading...
