3.
There
is
a
“button stop’’ on the shoulder belt that
keeps the belt from going too
far
into the retractor
at
the top
of
the seatback. Pull the shoulder belt out
of
the retractor, and place the guide over the belt. Make
sure that the guide
is
between the button stop
on
the
belt and the retractor. Insert the two edges
of
the belt
into the slots
of
the guide.
4.
Be sure that the belt is not twisted and it lies flat. The
elastic cord must be under the belt and the guide on
top.
5.
Buckle the belt around the child, and make sure that
both the lap belt and the shoulder belt are secured
properly. Make sure that the shoulder belt crosses the
shoulder. See “Safety Belts, Rear Seat Passengers”
in
the Index.
1-28
To Next Page
Loading...
