Oldsmobile Cutlass Supreme 1993 - Page 246

244
To Replace a Headlight (CONT.)
2. Remove the Torx@ head screws at the
end of the aiming ring. The aiming
ring will swing open like
a gate.
3. Remove the aiming ring from the
assembly.
4. Remove the wiring connector from
the headlight socket by lifting the
plastic locking tabs on the connector
and pulling it from the socket.
5. Check the new headlight again. The
number on the top of the light
(A)
must match the number on the
headlight being replaced. The letter,
“U” or “L,” must also match.