Programming the
Module
You will need to program your Remote
Lock Control module if any of the
following things occur:
You replace your Remote Lock
Control transmitter;
You add
a
second transmitter;
Something grounds the data encoder
You
replace the Remote Lock Control
connector in the trunk;
module.
To
program the module, you'll need the
transmitter and a short length of wire,
about
3
feet
(1
m) long. Then follow
these steps:
1.
Open the trunk and locate the data
encoder connector
(A).
It's on the
right side, above the wheel well.
2.
Attach one end of the grounding wke
to the stud inside the data encoder
connector terminal.
3.
Attach the other end of the wire to a
ground
(B).
4.
Press any button on the transmitter
once. Wait for the locks to fully cycle.
If
you have a second portable
transmitter, press any button on it,
once, also. Wait for the locks to fully
cycle. Your module is now
programmed.
5.
Disconnect the wire Gom the data
encoder connector and the ground.
Theft
Vehicle theft is big business, especially
in some cities.
Although your Oldsmobile has a number
of theft-deterrent features, we lmow
that nothing we put on it can make it
impossible to-steaL However, there are
ways you can help.
Key
in the Ignition:
If
you walk away
from your vehicle with the keys inside,
it's
an
easy target for joy riders or
professional thieves-so don't do it.
When you park your Oldsmobile and
open the driver's door, you'll hear a
tone reminding you to remove your key
from the ignition and take it with you.
Always do this. Your steering wheel will
be locked, .and
so
will your ignition and
transaxle. And remember to lock the
doors.
51
To Next Page
Loading...
