Oldsmobile Cutlass Supreme 1993 - Cleaning the Outside of the Windshield and Wiper Blades

Sewice & Appearance Care
264
Inside Center High-Mounted
SfOP/@hf (4-DOOR MODELS)
For the type of bulb, see the Index
under Replacement Bulbs.
If you would like to clean the inside
surface of the rear window or need to
replace a bulb, you can remove the
stoplight housing by following these
steps:
1. Remove the two Phillips-head screws
2. Pull down the cover.
3. Unclip the bulb socket from the
4. Pull the bulb out to replace. Push in a
from the cover.
housing.
new bulb.
5. Press the bulb socket back into the
housing.
6. Remove the lens to clean the window
by pressing in
on the ends of the lens.
7. Replace the cover.
Cleaning the Outside of the
Windshield and Wiper Blades
If the windshield is not clear after using
the windshield washer, or
if the wiper
blade chatters when running, wax or
other material may be
on the blade or
windshield.
Clean the outside of the windshield
with
GM Windshield Cleaner, Bon-Ami
Powder@
(GM Part No. 105001 1). The
windshield is clean
if beads do not form
when you rinse it with water.
Clean the blade by wiping vigorously
with a cloth soaked in
full strength
windshield washer solvent. Then rinse
the blade with water.
Wiper blades should be checked
on a
regular basis and replaced when worn.