Features
&
Controls
78
Daytime Running Lights
(CONK)
At dusk, the exterior lights will come on
automatically and the low beams will
change to full brightness. At dawn, the
exterior lights will go out and the low
beams will change to the reduced
brightness of
DRL
(if the headlight
switch is off).
Of course, you may still turn on the
headlights any time you need to.
To
idle your vehicle with the DRL off,
set the parking brake while the ignition
is in the
Off
or
Lock
position. Then
start the vehicle. The DRL will stay off
until you release the parking brake.
Headlight High-Low Beam
Changer
To
change the headlights from low
beam to high or high to low, pull the
turn signal/headlight beam lever all the
way toward you. Then release it.
When the high beams are on,
a
blue
light on the instrument panel also will
be on.
Flash-to- Pass
Flash-to-pass lets you use your high
beam headlights
to
signal a driver in
front of you that you want to pass.
To
use it, pull the turn signal/headlight
beam lever toward you.
If
Your Headlights are
Off
Your high beam headlights will turn on.
They'll stay on
as
long as you hold the
lever there. Release the lever to turn
them off.
If
Your Headlights are
On:
No
flash-to-pass. Use the lever to
change between high and low beams, as
explained under
Headlight High-Low
Beam Changer
earlier in this section.
If
You
Have
Fog
Lights:
They go
off
whenever the high beams
are on. When the high beams go
off,
the
fog lights will come on again, if the fog
light switch is on.
To Next Page
Loading...
