Glass
Glass should be cleaned often. GM
Glass Cleaner
(GM
Part
No.
1050427)
or a liquid household glass cleaner will
remove normal tobacco smoke and dust
films.
Don’t
use abrasive cleaners on glass,
because they may cause scratches.
Avoid placing decals-
on
the inside rear
window, since they may have to
be
scraped
off
later.
If
abrasive cleaners are used
on
the
inside
of
the rear window, an electric
defogger element may be damaged.
Any
temporary license should not be
attached across the defogger grid.
Inside Center High-Mounted
stOp/ight
(2-DOOR
MODELS)
For
the type
of
bulb, see the
Index
under
Replacement
Bulbs.
If
you
would
like
to
clean the inside
surface
of
the rear window or need
to
replace a bulb,
you
can remove the
stoplight housing by following these
steps:
1.
Remove the two Phillips-head screws
from the cover.
2.
Remove the cover.
3.
Unclip the bulb carrier.
4.
Pull the bulb
out
to replace. Push
in
a
5.
Clip the bulb carrier back into place.
6.
To
remove the stoplight lens to clean
the window, remove the
two
nuts
on
either side
of
the housing.
new bulb.
7.
Replace the cover.
263
To Next Page
Loading...
