Olimpia splendid CALDO UP T - E - Switching off Delay Mode; F - Flap Functioning; G - Weekly Timer Mode

EN - 14
ENGLISH
If the set temperature is greatly higher than the ambient one (>3°C), the maximum
power heating function activates automatically (FAN and HIGH LEDs turned on).
If the set temperature is lower than the ambient one, the fan function activates auto-
matically (FAN LED turned on).
The set temperature can be changed at any moment during functioning.
3.4.e - Switching o󰀨 delay mode
Press button when the appliance is functioning to activate and set the switching
off delay mode; the TIMER LED on the appliance display turns on and the value
is shown.
Press the button once or more to set the desired delay (from 1 to 8 hours) after
which the unit will turn off.
Wait approximately 5 seconds without pressing any button: the delay will be set and
the TIMER LED will turn on the display.
After conrming the activation of the timer, it is possible to change the functioning mode at
any moment by pressing button . Once the set time has passed, the unit will turn off.
To cancel the delayed switching off, press button and the unit will switch to stand-
by mode or, as an alternatively, repeat the setting procedure of the delay, entering the
value .
 Itispossibletosetthedesireddelayuntilthehoursnumericsymbolashes.
Oncesettingisover,after5seconds,thenumericvaluestopashingandit
isautomaticallymemorized.Isit’sdesiredtofurtherchangethedelaytime,
it’snecessarytorepeattheoperationfromthebeginning.
 Theweeklytimerandthisfunctioncanbesetatthesametime.
3.4.f - Flap functioning
When the appliance is on, pressing button will cause the ap to start oscillating.
If it is desired to stop the ap in a certain position to direct the air ow, press button
again when the ap is oriented as desired.
Press the button one more time to start the ap oscillation again.
3.4.g - Weekly Timer mode
 Thismodecanonlybestartedwhentheapplianceisinheating(itcannotbe
startedwhentheapplianceisworkingasafanonly)orinsettemperature
mode.
It is needed to set the current day and hour before using this function.