0797S20067 4-1
OPERATING INSTRUCTIONS
CAUTION
ALWAYS USE CARE WHENEVER WORKING NEAR THE CUTTING KNIVES.
Adjusting the Gravity Feed Slicer’s Holddown
Loosen the holddown adjustment knob. Adjust the holddown so that the product just
clears the bottom edge of the holddown as it passes through the cutting knives. Tighten
the holddown adjustment knob when the holddown is in the desired location. See the
illustration below. Proper adjustment of the holddown will prevent the product from
jumping as it passes through the cutting knives increasing cutting efficiency.
To Next Page
Loading...
