0797S20069 6-1
MAINTENANCE
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Cleaning
Use a mild detergent solution to clean all exterior surfaces and empty the crumb tray
daily or more often if necessary. Periodically swing out the discharge table to allow
access to the drive area of the machine, then brush, blow, (if compressed air is
available), or wipe all foreign material from all surfaces, especially from moving parts.
Lubrication
Once a month, more often during heavy use, put a drop of food approved lubricant on
each of the pivot points, of the plastic links, at the top to the blade frames. All other
bearings are either grease packed or sealed and seldom need attention.
CAUTION
NEVER OIL OR GREASE THE MOTOR.
To Next Page
Loading...
