0797S20069 6-2
Removing the Blade Frames
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Swing out the discharge table from the slicer. See the next illustration.
Always start by removing the discharge side blade frame first. Both blade frames should
be removed from the discharge side of the machine, (see the note below). You should
remove the discharge side blade frame completely from the machine before starting on
the infeed side blade frame. However each is removed using similar procedures.
NOTE
ON MACHINES EQUIPPED WITH POWER BELT INFEEDS, THE INFEED
SIDE BLADE FRAME IS NOT REMOVED. A SPECIAL BLADE CHANGING
TOOL IS PROVIDED ON NEW MACHINES WHICH ALLOWS CHANGING
OF THE BLADES, IN THE MACHINE.
To Next Page
Loading...
