0797S20069 6-6
Changing the Blades (Continued)
The new knife can be installed by reversing the removal procedure. A paper clip can be
used to hold the knife in position on the lower pin to ease installation. See the illustration
below.
NOTE
WHEN REPLACING ALL THE KNIVES, ALWAYS REMOVE THE CENTER KNIVES
FIRST AND WORK TOWARD THE ENDS. INSTALL THE NEW KNIVES AT THE
ENDS FIRST AND WORK ALTERNATELY TOWARD THE CENTER.
CAUTION
NEVER
PUT BLADE FRAMES IN THE SLICER WITHOUT KNIVES.
To Next Page
Loading...
