Olivetti d-Color MF554 - Operation Flow; Checking the Cable Connection; Checking Network Settings of this Machine

d-COLOR MF654/MF554/MF454/MF364/MF304/MF254 3-15
3.2 Scan-to-Send function
3
Operation flow
The following describes a transmission flow. For details, refer to page 3-20.
1 Loading the original
2 Selecting a destination
% Select a registered destination, and check the settings such as the file type and image quality.
3 Press the Start key.
% Press the Start key to scan the original.
Checking the cable connection
Check that a LAN cable is connected to the LAN port of this ma-
chine and the green LED is on.
Checking network settings of this machine
Tap [Utility], and select [Device Information]. Then, check that the IP address is displayed.
Tips
- In general, the default settings are available for network connection; however, some network environ-
ments require a change on network settings.
- If no IP address is displayed, you need to configure the network. Tap [Utility], and select [Administrator
Settings] - [Network Settings] - [TCP/IP Settings]. Configure the required settings to suit your environ-
ment. For details, refer to the User's Guide CD/DVD.
• For IPv4 environment • For IPv6 environment