27
PROTECT
SETTING UP THE BASE UNIT
• The voice message is repeated a total of three times.
If the subscriber does not press digit key [1] on his
phone, the connection is automatically ended and the
next phone number dialled.
7KHWHOHSKRQHXQLWDQGDODUPDUHVZLWFKHGR
• after pressing the key on the remote control,
• after entering your entry code on the base unit and
FRQȴUPLQJZLWK or
• when the person called ends the current connection.
The base unit is then in Silent mode.
Setting the Trigger Delay
You can set the actual alarm to be triggered after a delay.
7KLVSURYLGHV\RXZLWKVXɝFLHQWWLPHWRHQWHU\RXUDSDUW-
ment or house and disarm the alarm system.
You can set a trigger delay between 0 and 240 seconds.
You can also select whether an acoustic signal (count-
down) should be issued from the base unit during this
period or not.
If one of the sensors is tripped, the base unit must
be disarmed within the trigger delay period to
ensure no alarm is triggered.
1 Select the Alarm Setup menu option.
2 &RQȴUPE\SUHVVLQJ.
3 Select the Trigger Delay menu option.
4 &RQȴUPE\SUHVVLQJ.
5 Set the delay time.
6 &RQȴUPE\SUHVVLQJ.
7 Select the Trigger Tone menu option.
8 &RQȴUPE\SUHVVLQJ.
9 Set the trigger tone to On or 2.
10 &RQȴUPE\SUHVVLQJ.
To Next Page
Loading...
Need help?
General
