BTX III — Getting Started Guide EN-5
4. Fully insert the sample carrier back into the sample chamber, making sure that side A and the
“Align Sample Here” arrow are oriented as shown below.
5. Lock the sample carrier in place by pushing down the lever.
6. In the main display, select Start Acquisition.
7. Press the Check button ( ) to start the test.
Equipment Disposal
Before disposing of the BTX III, check your local laws, rules, and regulations, and follow them
accordingly.
General Warnings
Instruments with a damaged detector or tube must be returned to your local distributor or the
manufacturer. Care should be taken to limit the release of beryllium from the instrument.
Electrical Warnings
The instrument must only be connected to a power source corresponding to the type indicated on the
rating label.
If an unauthorized power supply cord is used to power the instrument, Olympus cannot guarantee
the electrical safety of the equipment.
Trademarks
All brands are trademarks or registered trademarks of their respective owners and third-party entities.
To Next Page
Loading...
