Olympus bx40 - Page 124

BX Stage B. REPAIR PROCEDURE
3-2 Adjustment of working force of X-GUIDE UNIT
(1)
Set
the
block
@)of
JIG
(BXKCOO1)
©
to
the
position
of
"SV-X".
(2) Set the STAGE ① to the JIG (BXKC001) © , and fasten it with four pieces
of KNOB ③) .
(3) Screw in and out four pieces of KNOB (3) so that the X-GUIDE UNIT (4)
can work without play, uneveness, jumping, etc. and the working force
can be within the following standard.
Standard 8 ~ 15g The tension gauge 110g (0T0085) is to be used.
(4) After adjusting the X-GUIDE © position, tighten four screws firmly.
Screw AB3x4SA 4 pcs. (*1)