How to Install the IX-SVL2/BX3-SSU Stage
* IX-SVL2 cannot be used concurrently with condenser BX3-UCD8A or U-UCD8-2.
1. Install the stage fixing pillar using the provided clamping screws and Allen wrench. Be sure not to mistake the left and
right.
2. After attaching the rear side of the stage on the microscope frame, tighten the clamping screws on the side of the stage
fixing pillar.
Cross stage*
IX-SVL2
Scanning stage with ultrasonic
BX3-SSU
Stage fixing pillar
Clamping screws
Clamping screws
To Next Page
Loading...
