This setting is lost at power-off.
The setting always resets to ESP when you turn the camera on.
How to shoot when using spot metering...
1 Aim the camera so that the area you wish
to expose for is at the center of the
monitor (inside the autofocus target mark).
2 Half-press the shutter release button and
continue holding it. Keep the camera
steady until the green lamp comes on
solid and the autofocus target mark goes
off.
• The exposure and focus are now set.
3 Continue holding at half-press while
repositioning the camera as necessary.
Then full-press the button to take the
picture.
118
Monitor
Light Metering: ESP or SPOT (continued)
To Next Page
Loading...
