59
2
The Basics
Removing an Empty Film Pack
When the remaining film count (p.45) falls to 0 and you are ready to remove or replace
the pack, follow the steps below.
1 Turn the mode dial to OFF.
• The monitor goes dark and the camera’s
power goes off.
2 Press and raise the film compartment
latch.
• The compartment cover opens.
3 Remove the film pack.
You can now proceed to load a new film
pack. Refer to “Loading a Film Pack,”
Step 3 (p.36).
4 Close the compartment cover, so that it
locks into place.
WARNING
• Do not tear, cut, or otherwise rupture finished prints or unused film. The film contains
sealed-in emulsion that may leak out and cause alkaline burns.
• The film pack contains its own battery. Do not disassemble, heat, short-circuit, or
attempt to recharge this battery, and do not dispose of the battery in fire, as any of
these actions may cause the battery to explode, leading to possible fire or injury.
• Dispose of the used film pack in accordance with instructions provided on the pack’s
original packing.
To Next Page
Loading...
