Olympus CAMEDIA C-211 Zoom - REC View (Monitor Power Save)

171
8
Customizing the Environment
REC View
(Monitor Power Save)
After you take a shot, the camera requires a certain interval of time before it is ready to
take the next shot. Under the factory setting, the monitor continues to display an image
during this interval. To conserve battery power, however, you may wish to change the
setting so that the monitor goes dark after you snap the picture, and remains dark until
the camera is ready to shoot again.
For details about how to use the Setup menu, see “Using the Setup
menu” on page 167.
ON:
Keep the monitor on continuously. (This is the
factory setting.)
OFF:
Turn the monitor off until the camera is ready to
shoot again (until the green lamp stops rapid
blinking).
[
1/2
]
CHANGE
[
ON
]
[
ON
]
[
LOW
]
[
NAME RESET
]
FILE
Select from menu...
Select to move to the
REC View screen.
OK
SET
BACK
ON
OFF
Make the setting...